HGW 132855 1/32 Nakajima B5N Kate (Opened Canopy) Seatbelts and Masks for Infinity Models [Basic Line]

Basic Line contains:
1x Seatbelts 1/32
1x Masks 1/32

Seatbelts Features
- Contains micro-fabric and photo-etched highly detailed parts
- Belts are fully functional - modeler can leave them un/fastened
- Made from printed micro-fabric material which behaves like a piece of rag
- Textile parts are prepared for using filters and other agents (they are waterproof and resistant to common nonaggresive modeling preparations

Seatbelts INSTRUCTIONS
1. Take the precut textile part out of the sheet.
2. Remove the carrier paper.
3. Bunch the belts up and knead them between the fingers.
4. Thread the belts through the photo etched buckles - use superglue.
5. Put them into the seat.
6. Spray with glossy varnish.
7. Spray with matt varnish.
8. Impregnate the seat belts with very diluted oil colour (mix of black and brown) texture highlight.

Paint Mask:
Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by tracing all the indentations with a pointed wooden stick.
Painting method: Try not to apply two coats of colour at the edges of a mask. Instead, apply one colour prior to painting the proper camouflage, and apply the other colour after the mask is back on. Otherwise, the coating in the areas encased by the mask may be too thick, and after removing the mask the edges of the lighter colour may become visible.